This is a 3D-printed gauge pod/holder designed for the factory Lamco® gauges that came standard on all Evo 8/9 MR's. The gauges are originally located in the lower cubby near the shifter which are almost impossible to view while driving. A common solution is to switch the location of these gauges with the radio, however the gauges are still not angled for optimal viewing and they are also now exposed to sunlight through the windshield. The faces and needles will get faded over time! This gauge pod was designed to remedy these issues by angling the gauge faces towards the driver for better visibility and recess the gauges for protection against the sun exposure. This is what the Evo 8/9 MR's should have came with from the factory!

100% bolt-on installation, no modifications needed.

Works for LHD and RHD vehicles (flip for correct direction)

Made of ASA for extreme heat, impact and UV resistance! ASA possesses all the durability of ABS with less shrinkage less warpage and higher printing accuracy.

Hardware is quality stainless steel.

Designed to work with existing mounting hardware on the MR gauges.

Strategically printed with calibrated print settings for a smooth front face and a factory finish.

Large mounting holes allow for slight variance in positioning, if needed.

DOES NOT INCLUDE GAUGES. GAUGES SHOWN ONLY FOR REFERENCE.

All gauge pods come pre-assembled.

Designed, printed and assembled in the USA!