This plug and play PID Programmable Ramp and Soak (60 segments) temperature controller with circuit breaker, buzzer and flasher alarm and Ceramic thermocouple, has a wide range of applications in controlling the temperature of Kilns, Ovens, Furnaces, pottery, Glass, Annealing, ....(for loading current up to 15Amp) . This is an inexpensive and heavy duty plug and play controller box.

 
All products are 100% Brand new, High performance and Top quality.
Controller comes in Box with MANUAL.
Guarantee your Insured Undamaged shipping by purchasing from a Canada located seller.
Ready for Immediate Shipment.
 

Features & Specifications:

 

·      Its heavy duty kiln thermocouple can measure very high temperatures up to 2372 °F (1300 °C).

·      To operate, you only need to plug the heater to the socket wire of the controller at the back, drop the sensor into the Kiln, turn on the power of controller and adjust it to your own requirements.

·         Display temperature in Celsius or Fahrenheit

·         Heavy duty input and output plug and socket wire

·         Equipped with circuit breaker switch 15Amp (The circuit breaker can be reset and used over and over, where a fuse is a one shot deal and has to be replaced)

·        Equipped with buzzer and flasher alarm for passing the temperature range & thermocouple failure

·        Equipped with Thermocouple male and female connector for changing thermocouple and also  wall mount box ear for easy installing on oven or wall. 

·         Equipped with 40amp SSR with large Heat sink

 

Specifications:

Input voltage

90 to 265 VAC - 50 /60 Hz; No transformer or adaptor is required.

Output voltage

Same as the input.

Maximum Current

15A

Controller Mode

60 segments Ramp and soak PID control

Output switching device

Solid State Relay (max 15A - 24/240V AC) with zero voltage crossing switching.

Sensor Type

Type K 6pc Ceramic Kiln Thermocouple

Temperature control range

50 to 1300 °C

Thermocouple Thread material

Cr-Ni, Si-Ni

Thermocouple Thread dimensions

3.2mm (diameter ɸ) x 190 mm (long) / (0.13" x 7.5")

Sensor cable length

3.3 ft (1m)

Ceramic tube shape

6 x (1 inch Pcs, two-hole insulator) Ceramic Tube

Ceramic tube diameter

Oval shape: L=12.3 mm & W=10mm (L~ 0.5” & W~ 0.4”)

Ceramic tube length

~150 mm (~ 6.0 inch)

Box material

ABS

Temperature resolution

Dual 4-digit LED display, 0.1 °C.

Temperature display unit

Celsius (°C)

Temperature accuracy

±0.5%F.S

Dimension

200x120x75mm ( 7 3/4 x 4 3/4 x 3" )

 

Temperature controller specification:

Available Segments

Up to 60 segments available for a program

Detective Temperature Range

-200 to 1800 °C (depends on input type)

Patterns

Be able to program different patterns with different segments

Input

Thermocouple: (K,S,E,J,T,B,N)
RTD: (Cu50, PT100)

Linear Voltage and current:0-5V,1-5V,0-1V,0-100mV,0-20mV,0-60mV,0.2-1V(100-500mV),-20 -+20mV(0-10V) -5V- +5V(0-50V), -100 - +100mV(2-10V)
Linear Resistor:0-80 Ohm, 0-400 Ohm

Output

Voltage pulse to drive SSR

Control action

Heating , Cooling

Response time

Less than 0.5S (configurable)

Accuracy

0.2%FS+- 0.1C(Cu50 cooper resistor compensation or ice point compensation)
0.2%FS+0.2C (TC input and internal compensation)

Temperature drift

Less than 0.01%FS 0C (Typical value is 50ppm/0C)

Resolution

10C or 0.10C(automatically change to 10C when the temperature is higher than 999)

Display

Dual line - four digit - LED display

Decimal points

Configurable for all inputs

Control Method

ON/OFF

AI MPT with auto tuning, adopting fuzzy logic PID algorithm

Auto/Manual Control

Auto/manual bump less transfer from front panel

Auto-tuning

Auto-tuning and manual tuning available

Alarm Mode

Absolute value high limit, Absolute value low limit, Deviation high limit alarm, Deviation low limit alarm.

Alarm stand by

In some occasions, for example, in the heating process, when the alarm is set to as low deviation alarm, right after the power is turned on, the alarm will be triggered but there is no problem in the system, the alarm block function can solve this problem.

Soft start function

In some particular application, 100% output ratio is not allowed when the power just turned on; soft start function is a great feature to solve this problem.

SV re-transmission output

available, as feed of PLC or indicator or paperless recorder

Power Supply

90~260VAC

Dimension (DIN 1/8)

96mm*48mm (Horizontal)

Mounting

Panel Mount

 

Notes for customer outside North America,

  • For international order, an US power cord is included. User can cut plug and socket wire and change it to the power plug and socket outlet that meets the local standard for the input and output. 

  • For countries that use 220-240VAC power line, the maximum control power of this controller is 3300 Watts.

 Our shipping service is fast for example:

shipping to USA is 3-6 business days

shipping to England and Ireland is 4-7 business days

shipping to other Europe Countries 5-10 business days

shipping to Canada is 2-7 business days

shipping to Australia, New Zealand and Asia takes longer than other countries (17-25 Business days)