THIS IS ONLY THE GPIO'4'CARS BOARD (v.1.5c), SEND WITHOUT ODROID N2!!!!
PLEASE VISIT AND READ WITH ATTENTION THIS LINK BEFORE ORDERING:
https://forum.odroid.com/viewtopic.php?f=182&t=45350
You will find any information needed, and a tutorial to use this board.
I WILL NOT ACCEPT RETURNS AS THIS IS A SPECIFIC PRODUCT, YOU NEED TO KNOW FOR WHAT IT IS INTENTED.
Many versions are available, because everyone has specific needs.
I send GPIO'4'Cars board, with 2 plastic clips for fixing the board to the Odroid N2.
Here is more information:
- VU7C:
If you need to use VU7C screen from Hardkernel, please be careful if you use ribbon cable more than 1ft (30cm), you will probably face bad behavior (screen initialization problem). This has nothing to do with GPIO'4'Cars board, this is due to I2C specifications. So to prevent this I add to the board LTC4311 chip, it helps keep good signal between N2 and VU7C.
I can add 40 pin ribbon cable for connecting VU7C, please tell me.
- Connector:
If you choose Screw terminal, you need to wire yourself the board to your car.
If you choose ATX, I send wiring hardness 3ft (1 meter), one side ATX connector to the board, the other side ISO standard connector to your car, like this one.
- Cables:
One DC to DC connector cable 10cm (8inch) for connecting the board to the N2,
One reset button with cable 50cm (20inch),
One 8pin ribbon cable for SWC connector 50cm (20inch) with extension board.
- Output:
Add MOSFET for output switch, to control any 12V device (around 4A Max.)
Please contact me for more information or specific demand.
Thanks.