The lamp has parameters 12AX7 only through an adapter block!!!

The main dimensions of the 6N2P lamp.

 
Triode 6N2P is designed to amplify low frequency voltage.
Used in resistor pre-amplification stages.
Indirectly heated oxide cathode.
Works in any position. Produced in glass finger design. Service life is not less than 500 hours.
Pin base with a button bottom. Pins 9.
 

Interelectrode capacitances, pF

The input of each triode is 2.95 + -0.45. The output of the first triode is 2.9 + -0.7. The output of the second triode is 3.1 + -0.7. The throughput of each triode is 0.7 + -0.1. Between the anodes no more than 0.3.
 

Electrical rating (for each triode)

Heating voltage, V6.3
Anode voltage, V250
Bias voltage on the first grid, V-1.5
Filament current, mA345 + -25
Anode circuit current, mA2.3 + -0.9
Slope of characteristic, mA / V2 + -0.5
Slope at a filament voltage of 5.7 V, mA / Vnot less than 1.3
Internal resistance, kOhm50
Gain97.5 + -17.5
 

Maximum permissible electrical values ​​(for each triode)

The highest heating voltage, V7.0
The lowest heating voltage, V5.7
The highest voltage at the anode, V300
The greatest power dissipated at the anode, W1.0
The greatest constant voltage between the cathode and the heater, V100
The highest current in the cathode circuit, mAten
The highest leakage current between the cathode and the heater, μAfifteen
The greatest resistance in the grid circuit, MOhm.0.5