These resin 3d prints have crisp detail, and don't suffer from the same layer lines that are the bane of regular PLA prints. If you do find any, they will be much easier to correct, as the resin is so easy to sand or scrape with a hobby knife blade. So if you're looking for a finer finish for your vehicles, they are definately the way to go.

There will be very small pinhead sized lumps that may need slicing or sanding off, but these will be mainly confined to the undersides, and are a result of the supports needed during printing (they are printed hanging upside down from the build plate) and are unavoidable. I do take off the majority, but I don't want to take all the fun out of it for you!

I can't help the cost of international postage, but I can fit a lot of models into a single box, so the more you order, the cheaper it becomes!

I have quoted just over 3 weeks for dispatch, as they are printed to order. I do endeavour to get them out earlier than that, but due to high demand, it's not always possible. Keep checking back, as I am always adding new models.