Pentair - IntelliBrite 5G Color Light Engine Kit, 2nd Generation Circuit Board
Pentair IntelliBrite 5G Color Light Engine Kit, 2nd Generation 2010 to Current- 619818Z. The IntelliBrite 5G Light Engine Kit 619818Z is a Genuine Pentair replacement part and comes with a new wire tension clamp, 8-3/8" silicon lens gasket, and light engine assembly.
Product Specifications:
- Circuit Board
- Uni-Tension
Wire Clamp Assembly
- Gasket - 8
3/8 In (20.9cm) Silicon Diameter, Off-White
Special Note:
1. Using a 1/4 in (0.64 cm) nut driver, carefully remove the four retainer nuts from the light assembly (see illustration on next page). Place the nuts aside for reinstallation.
2. Unplug the two connector plugs from the circuit board. Lift up the circuit board and remove it from the light housing base.
3. Carefully lift off the old thermal strips from the base of the light housing base and discard.
4. Place the two new thermal strips (provided) over the circuit board studs in the base of the light housing.
5. Place the light circuit board over the base studs and seat the circuit board on top of the thermal strips. Be sure the two connecting wires are not caught between the housing and the edge of the circuit board.
6. Using a 1/4 in (0.64 cm) nut driver, tighten each of the four retaining nuts to a torque value of 6.0 (minimum) to 8.0 (maximum) in-lbs to secure the circuit board.
*This product can't be returned, due to it can be sold as new electrical product if opened.