RedPill - The ESP32-S3 development kit
USB-C, 8MB Flash, 2MB PSRAM
The RedPill development kit is built with the ESP32-S3-WROOM-1 module from Espressif, with 8MB of Flash and 2MB PSRAM.
The narrow format allows for use on a breadboard and access to pins on both sides.
Additionally, it has a RGB addressable LED (Neopixel / SK6812), connected to the GPIO3 pin.
Main specifications:
- 32-bit Xtensa(r) dual-core LX7 @240MHz
- WiFi 802.11 b/g/n 2.4GHz + BLE 5, Bluetooth mesh
- 8 MB Flash
- 2 MB PSRAM
- 512 KB SRAM
- 16 KB SRAM in RTC
- 384KB ROM
- 36 exposed GPIOs
- SPI, UART, I2C, I2S
- 14x Touch sensors
- USB 1.1 OTG
- 12bit ADC
- Neopixel RGB LED on GPIO3
- USB to Serial on board
- On-board PCB antenna
- Timers and Watchdogs
Applications:
- Generic Low-power IoT Sensor Hub
- Generic Low-power IoT Data Loggers
- Smart Building
- Industrial Automation
- Wi-Fi enabled Toys
- Wearable Electronics
- etc
Shipped with pre-written firmware based on your selection. Default comes with MicroPython unless otherwise specified.
Shipped with pin header based on your selection. Default comes with unsoldered pins unless otherwise specified.
Technical details and tutorials: https://munich-labs.com/