This listing is for an OptiWand Bullseye 2 pack soft contact lens insertion and removal tool.
This is our largest model and is best for those with long fingernails or large, rough fingers.
OptiWand Bullseye® Soft
Contact Lens Insertion
Use the Bullseye End to
Insert Lenses
Step 1: Apply Eye Drops and dip your OptiWand Bullseye® in Contact Lens solution for lubrication!
Lubrication is Vital for proper transfer of
the lens to the eye.
Using Eye Drops prior to
insertion is a MUST! Move Quickly as Lenses Shrivel Fast
when out of Solution!
Step 2: Position your SOFT
contact lens on the center of the OptiWand Bullseye® End.
Step 3: Using a Light
Source, center the OptiWand Bullseye® to your eye by
looking through the Center Hole.
Do Not Look Up or Down as
the Wand may hold the Lens.
Step 4: Using your
non-dominant hand spread your eye lids keeping your eyelashes out of the
way then draw
the OptiWand Bullseye® toward your eye until the lens
touches it gently.
Step 5: Blink
until comfortable. Now your lens is centered on your eye.
OptiWand Bullseye® 2 Pack Soft
Contact Lens Insertion & Removal Tools
You can use Either End to
Remove.
Step 1: Apply Eye Drops for
Lubrication. Use a Dry OptiWand Bullseye ® for
Contact Lens Removal
Step 2: Using your
non-dominant hand, Spread your eyelid as wide as possible,
keeping eyelashes out of
the way.
Step 3: Focusing on
the Center Hole, draw the OptiWand Bullseye®
toward your eye
until you touch the soft contact lens gently.
Step 4: When you feel the
OptiWand Bullseye® touch the contact lens, carefully pinch and
swipe away from the eye.
Some can Push the lens
down and out if you are unable to PINCH it. Some can angle the wand up and
pinch the lower half of
the lens while using a
mirror as a guide.
*Best pinching position is
very close to the tip*
You CANNOT suction soft lenses by placing the OptiWand Bullseye® against them.
You can Pinch them out with either soft pliable end. Try
Both Ends.
Practice removal by placing a Soft Lens on your index or other finger and pinching it with the
cup to get a feel for actual use. Never use on a naked eye!
USE ONLY AS DIRECTED!
These statements have not been evaluated by the Food and Drug Administration.
This product is not intended to diagnose, treat, cure, or prevent any disease.
Please read and follow instructions as well as view the instructional videos for best results.
OptiWand®, OptiWand Pincher®, OptiWand Bullseye®, OptiWand Hard®,
OptiCase® & OptiAide are disposable products.
We suggest replacing after 30 Days if used daily.
To clean use soft soap, rinse thoroughly and air dry. Not dishwasher tested.
Please DO NOT USE any OptiWand® if you are allergic to Liquid Silicone Rubber!
OptiWand®, OptiWand Pincher®, OptiWand Bullseye®, OptiWand Hard® & OptiCase®
are registered trademarks of TJSC Optix Inc.
No claim is made to the exclusive right to use
the following part from the mark as shown: “Hard”
No claim is made to the exclusive right to use
the following part from the mark as shown: “Pincher”
All rights reserved.