For Under Tiles, Vinyl & Amtico

Highest quality electric underfloor heating engineered in

Germany for under tiles, vinyl and Amtico.

Web-Tech Underfloor Heating Cable Mat

1 Easy to install with sticky underside

2 Low cost

3 Minimal wiring and earth shielded

4 Primary Heating - The powerful output is enough

to provide complete heating in most

rooms at 150W/m2

5 Ultra thin & fast response time

Please note that all mat sizes have a standard width of 0.5m

Under Tiles

1 Tiles

2 Flexible Tile Adhesive 8mm

3 Heating Cable Mat

4 Insomax, Marmox or Equivalent Insulation

5 Flexible Tile Adhesive

6 Floor Slab

Under Vinyl/Amtico

Simply pour latex based self-levelling compound on top of the cable and insulation before glueing the vinyl or Amtico on top.

Web-Tech Underfloor Heating Cable Mat

Basic Installation Method

Ensure all mats are working by testing the cables using a multi-meter.

This is not an installation guide. Please read the full installation manual before installing.

Web-Tech Underfloor Heating Cable Mat

1 Prepare sub-floor

by removing all dust and debris.

 

2 Fix Insomax insulation

to the sub-floor using a flexible tile adhesive. Ensure that the whole surface is covered [image a].

 

3 Position the Web-Tech Mats

Once the insulation is fixed, unroll and correctly position the Web-Tech Mats. [image b]

 

4 Make turns in the mat.

Cut the mesh to make turns in the mat. Be careful not to cut the wire itself! [image c, d, e]

 

5 Run the cold cable to the thermostat

 

6 Re-test the mats

Re-test the mats to ensure none have been damaged during installation.

 

7 Lay the thermostat floor sensor

in the conduit and place between mat turns.

 

8 Start tiling

With the system turned off, tile directly on top using a flexible tile adhesive. If the final flooring is vinyl or Amtico, use latex based self-levelling compound and lay the final flooring once dry.

Specification

Specification Mat Thickness : 4mm

Output Rating : 150W/m2

Double Conductor

Engineered in Germany