Brand New St Rear hugger ,  this is a very high quality piece, Kevlar re-inforced, you will be impressed when you see it! If you are not satisfied a refund will be given. CAll 0466507457 or Check out racecon.com.au

Method of manufacture Autoclave

Carbon fiber that is pre-impregnated (i.e. pre-preg) with epoxy resin is laid into the mold and then covered with releasing films and agents. The entire piece is then bagged and vacuumed clean of air. From there the piece is inserted into an autoclave, which is, basically, a large oven. The parts are heated to cure the carbon fiber and then the part is finished. Dry carbon parts can be produced with a much lower weight than wet lay-up parts since there is much less resin used Has a higher strength.