PLEASE READ DESCRIPTION THOROUGHLY and LOOK AT ALL THE PHOTOS

This sale is for a new can motor flywheel upgrade kit for the HO scale Mantua 2-6-6-2 or 2-6-6-2T articulated steam locomotive. This motor kit will provide good slow speed operation, A LOWER TOP SPEED, and operating noise will be reduced as well. This kit is designed to replace the old Pittman style open frame motor. This motor kit WILL NOT work in later version locomotives that have the new Mantua Power Drive can motor system or newer locomotives that are made in China. Make sure your locomotive has the older Pittman style open frame motor before purchasing this kit.

If you have any questions please contact me before purchasing this kit

The motor measures 25mm long x 20mm high x 15mm wide, the motor shaft is 10mm  long and 2mm in diameter. The flywheel is 16mm in diameter and is13mm long. The output shaft of the flywheel is 19mm long and 2mm in diameter. At 12 volts DC with no load, this motor draws 50ma and develops 7600 rpm, the stall current is 800ma. This motor is DCC compatible. This motor will start turning smoothly on 1 Volt DC and it is very quiet when operating.

If you have any questions please contact me before purchasing this kit

The kit consists of one flat can motor with flywheel, flexible coupling, flywheel shaft, hookup wire, and illustrated installation instructions.The first photo shows what the motor kit would look like installed on a Mantua 2-6-6-2T chassis. The 2nd photo shows the contents of the motor kit. What you see in the 2nd photo is what you will receive. PLEASE NOTE! The chassis shown in the photo IS NOT included with the motor kit. This is an easy kit to install, installation time is about 2 hours. This is an unassembled kit.

The motor kit will be shipped via USPS 1st Class Mail. 

 Note to international buyers: eBay determines the rates for international shipping, not me. I have no control over what eBay charges for international shipping

Thanks for looking.