GARRARD POWER SUPPLY CONNECTING & VOLTAGE CHANGE-OVER BLOCK
used on Garrard 301 Type A, RC88 and most pre-Lab 80 turntables

(Yep, that's what it's called)

SECOND GENERATION block with 110 Volts hard wired. Voltage can still be changed by re-soldering the motor leads in the back of the block
(motor coils in series for 110V, in parallel for 220V)



The junction box where the power cable goes in, the four motor wires go out and the wires to the switch go out.

This junction box came out of an Garrard Type A turntable. It is identical to what was used in Garrard 301 , as well as the later Type A, as well as the RCxx series, except for the RC98 and the 4HF.

Junction box made from brown bakelite plastic, 2x 7/8x1".

CONDITION: Item is in close to new condition, undamaged and uncorroded. Short stubs of wire have been left for connection, the two wires to the switch are full length about 13"

Great care has been taken to preserve all the multiple nuts, washers and lock washers, and leave them in the right order.

Click here for more Garrard Turntables and Parts