3d printed side AC vents for 96-98 trackers/sidekick.

They are friction fit, very snug, and snap into original holes. The vents are angled 15° to be aimed towards the windows and person to keep windows defogged.

If you’ve wanted to buy an original set, you know how ridiculously expensive they are, and the plastic always breaks. Also to install an original set requires the entire dash and duct system to be removed.

These will be matte black, but can do other colors if desired. Please send a message.

How to install.

- The original ones are screwed in from the inside.

- To install the 3d printed set, simply break/pull out all of the original vents.

- You’ll see old screws in two corners and there will be plastic still attached. Those can stay, these vents are shorter and designed to be pressed into place while not interfering with the left over screws and plastic bit.

- Once the 3D printed ones are pressed in, they are in for good! Just like the original ones, these are NOT meant to be removed!

You’ll be getting exactly what is shown in the pictures, please make sure you see what you are getting, and match them up with your current setup.

Thank you!