This listing is for a 15-mode mod kit for a Official Microsoft Xbox 360 wireless controller, this will not work with any other controller. Details listed below:

This is a stealth mod, to change modes, quickly press not hold the sync button.

**Please note, there is a known problem with Matrix 2 boards, if your controller is firing by itself, please disconnect the left trigger from the mod.

• MODE 1: 8sps (Dual rapid fire)
• MODE 2: 12sps (Dual rapid fire)
• MODE 3: 2sps
• MODE 4: 3sps
• MODE 5: 4sps
• MODE 6: 5sps
• MODE 7: 6sps
• MODE 8: 7sps
• MODE 9: 8sps
• MODE 10: 9sps
• MODE 11: 10sps
• MODE 12: 11sps
• MODE 13: 12sps
• MODE 14: 13sps
• MODE 15: 14sps

When you change modes, the LED will blink as many times as the mode in which you are ... example, if you are in 5, the LED flashes 5 times.

For modes above 10 then the LED will flash the number of times 10. Example: you are 14 and mode switching into 15, the LED flashes 5 times.

By pressing the button longer "Sync", you switch to "Standby", the Rapidfire is disabled (the LED will flash rapidly) , to get back again on the current mode simply press the "Sync" button, the mod will go back into the mode you were just in.

This mod kit contains the following:

• Programmed chip
• Two feet of 30 Awg wire
• 1N4148 diode (for older version controller only)
• A QR Code with a link to the PDF (instructions and a video link) will be attached to the envelope

**Also please watch the video, this is what the 3-mode kit does when installed, properly.**

If you have any questions, Please Ask