Generator Stator For Polaris ATP Big Boss Magnum Ranger Scrambler Sportsman Worker 500 cc 1999-2004

 

Brand new generator stator

Please note : Polaris often uses two to three stators for the same model. Please compare with our pictures.

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation.
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • Pick up pulsar coil included
  • Connector included
  • Rubber grommet included
  • All product shipped are tested
  • One year limited warranty

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Vehicle models fitment

 

Polaris Sportsman 400 -- 2003-2004
Polaris Sportsman 500 HO -- 2002-2003
Polaris Scrambler 500 4x4 -- 2002-2003
Polaris Worker 500 -- 2002
Polaris Magnum 500 HDS 4x4 -- 2002-2003
Polaris ATP 500 -- 2004
Polaris Scrambler 500 2x4 -- 2002
Polaris Ranger 500 6x6 -- 1999
Polaris Magnum 500 HDS 2x4 -- 2002
Polaris Magnum 500 RMK -- 2002
Polaris Ranger 500 Series 10 4x4 -- 2003
Polaris Ranger 500 Series 11 -- 2004
Polaris Sportsman 500 4x4 -- 2002-2003
Polaris Sportsman 500 6x6 -- 2002
Polaris Int'l Big Boss 500 -- 2002

OEM part replacement

 

3087168

Specifications

 

Dimensions :
Interior diameter : 47mm
Exterior diameter : 114mm
Thickness : 20mm
Length of wires stator to grommet : 155mm
Length of wires grommet to plug : 900mm
Length of pickup coil's wire to grommet : 60mm

Other specifications :
Number of wires : 7
Number of plugs : 9
Number of pins : 12

Wire to wire resistance :
Alternator : Yellow/Red to Yellow = 0.4ohms +/-20%
Pickup : White/Red to Red = 115ohms +/-20%
Source : Black to Red = 18ohms +/-20%

instructions

 

Before installing your new stator

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

RMSTATOR around the world