Integrated
high quality socket with 3.1 Amp USB dual accessory charger rubber mounting washer and sealing cap and mounting plate. Mounts in panels of unlimited thickness.
Ships
from the USA.
Charges iPhones, iPads, GPS.
Listing is for one3.1 amp USB charging socket all in one integrated design. Has two ports one charging at 2.1 amp and one charging at 1 amp. A tight fitting cap protects the USB ports when not in use. UV resistant. #U/sq/sw
Sealing front cap and rubber mounting washer makes the assembly vibration resistant and seals the mount.
Fits in a 1-1/8” hole. Can mount in panels of 1-1/4" with just the backing nut, or in panels of unlimited thickness with the mounting plate.
Over-current over-voltage, over-load and over-temperature protection.
The intelligent control will prolong the cycle life of
the battery.
Environmentally friendly, energy-saving, complying with the safe certification
standard.
High working efficiency: over 85%, good charging performance.
Rapid charging your phone safely and without overcharging your battery.
Replaces Blue Sea Systems equivalent.
Parameters:
1: Input : 12V
2: Output : 5V---3.1A
3: Rapid
charging for mobile phone
4: IC chip inside prevents overcharging and short circuit
Higher volume discounts available for 10 or more contact us.
Options:
-Add a USB plug connector boot. This is a vinyl boot that slips over your USB cable connector such that when the connector is inserted into the socket the boot covers the connection from weather. See item 110966193186
-Add a socket boot to increase the weather resistance of the socket. The boot covers the the wire contacts and has an exit for the wires. The socket boot may be purchase one per assembly when you buy this item. For a straight boot (shown above but not included in this listing) see this listing 120941435675. For a right angle boot for tight installations see this listing 110791911918 .
-Add a fuse holder to your socket installation. Always connect the socket to your battery with a fuse in between. This listing is for an inline waterproof fuse holder and a 15 amp ATO fuse. See listing 110968445581
-Add wires with a fused 60 inch (5ft) wire harness to your socket assembly. The harness comes with of a fuse holder and fuse, and red and black wire connectors to attach to your socket and battery. See 121264213736
-Add a double mounting plate. Allows you to mount two socket products side by side for a professional installation. See listing 121267652997
-Extended warranty. This product comes with a one year warranty for damage during normal use. Just return it for repair or replace. If you want to extend the basic warranty period to three years, buy this option 301125941663
-Add a socket switch waterproof-Single pole single throw (SPST). Rubber switch cover and sealed back fits in a socket hole. Wire crimp connections. See 121422944323.
-Add a mounting hole bore. Allows you to drill or enlarge a hole in your panel or dash to mount this product. See 121486220109.
-FREE FREE FREE domestic shipping on these options when you buy the item in this product listing. Just buy this listing and the options you need at the same time. Then send us a message after, to combine shipping and we will refund your shipping for the options. Applies to one of each select option only when purchased together.
-Add a four hole quad mounting plate. Allows you to construct a custom square panel/ dashboard of four socket elements; switch, alarm, voltmeter, USB charger and special socket type. See 121644713148.