I'm selling 3D printed connector Type 2 for charging electric vehicle. 

Just what you need to do is to solder the cable. Menekes is fully built with all the control resistors, diode and key that allows you to start filling and protecting it against theft. And also protect against unwanted interuption charging of random passangers .

It has 220R resistor for current of 32A.

1K3 and 2k7 are paralel for starting charging. 1K3 goes through button.

Fifth picture explanes how i put resistors and diode. My is 22Kw Version.

How to use:

Open with screwdriver. Do not damage the button wires.

Solder wires as shown on the scheme on the last picture.