Welcome to our page!

Are you fitting Older Audi or 57.1CB Wheels to a Newer Audi????

THESE ARE THE SPACERS FOR YOU!!

SPIGOT ADAPTERS ARE SOLD IN PAIRS WITH 10 x EXTENDED M14x1.5 WHEEL BOLTS 

TAPERED WHEEL BOLTS ARE SENT OUT WITH THIS LISTING 

FOR AFTERMARKET WHEELS 

• Hub bore - 66.5mm

• Hub PCD - 5x112

• Hub bolt thread - M14x1.5

• Wheel bore - 57.1

• Wheel PCD - 5x112

• Thickness - 20mm

LARGER 150mm outside diameter billets for the larger hubs!!

The Adapter/Spacers are 20mm wide giving 40mm overall increase across the axle.

These spacers are designed to fit a 66.5mm HUB and a 57.1mm WHEEL bore.

·         All our custom-made spacers and adapters are manufactured from 6082 T6 Solid billet Aluminium and machined by our skilled Engineers at our Barnsley HQ.

One of the most cost-effective mods on the market and easy to fit in 7 steps

• Simply unbolt your wheel and remove.
• Wire brush and wipe the bore and wheel hub clean, (must be dirt/rust free)
• Apply a little copper grease or similar to stop the faces sticking together.
• Slide the spacer on to your existing hub.
• Check the spacer is sitting flush against the original hub with no visible gap
• Gently position the wheel on to the spacer spigot taking care not to damage the machined surfaces.
• Secure the wheel with the extended bolts and torque them to the required spec.

Watfields Precision Engineering also manufacture custom parts as well as wheel spacers and adapters.

All our wheel spacers are manufactured from material sourced in the UK and are produced by Watfields Precision Engineering UK LTD. Visit www.watfields.com

Please contact us to discuss any enquiries you may have