HD 3000 1 Ohm Taramps Amplifier

With a maximum power of 3000 Watts RMS, the amplifier module of Taramps HD3000 is mono, impedance of 1 ohm and 1 channel. Perfectly match with all kinds of loudspeakers, drivers and tweeters in the right measure for you!

* This product comes with an M1 Led Monitor


Technical Information:

OPERATION CLASSClass D
NUMBER OF CHANNELS01
MAXIMUM POWER
@12.6VDC - 1 Ohm: 3000 Watts RMS
@12.6VDC - 2 Ohms: 2025 Watts RMS
@12.6VDC - 4 Ohms: 1140 Watts RMS
INPUT SENSITIVITY230mV
SIGNAL TO NOISE RATIO89dB
FREQUENCY RESPONSE10Hz Hz ~ 20 kHz (-3dB)
CROSSOVER HIGH PASS (HPF)10Hz ~ 80 Hz (-12dB/8ª) Variable
CROSSOVER LOW PASS (LPF)80Hz ~ Full (-12dB/8ª) Variable
BASS BOOST0 ~ 10.5dB (5 Hz)
THERMAL MANAGEMENTSmart Cooler (fan controlled by temperature or audio, with 3 speeds)
EFFICIENCY79%
INPUT IMPEDANCE18K ohms
OUTPUT IMPEDANCE1 Ohm
PROTECTION SYSTEMOutput Short circuit / High or Low supply voltage / Thermal protection
MIN. SUPPLY VOLTAGE9 VDC
MAXIMUM POWER SUPPLY VOLTAGE16 VDC
CONSUMPTION AT REST1.8A
MAXIMUM MUSIC CONSUMPTION@12.6VDC: 150.5A
MAXIMUM CONSUMPTION IN SINUSOIDAL SIGNAL@12.6VDC (1kHz): 301A
DIMENSIONS (H X W X D)9" x 2.56" x 7.32"
WEIGHT4.4lbs
EAN7898556840903


Warranty:
Taramps products come with a 1 year limited warranty from the manufacturer. This warranty does not cover: Burnt voice coils, abuse and damaged caused by improper use or installation, physical damage to the product cause by the consumer, installation charges incurred, damage to amplifiers when connected at less ohm load than specified by the manufacturer, damage to amplifiers caused by insufficient electrical requirements, water damage, excessive wear and tear, and any other cause implied in the warranty card supplied by the manufacturer.

Shipping:
We offer free Same-day shipping to the USA. For international shipping, please ask for availability.

Return Policy:

You may return most new, unopened items within 30 days of delivery for a full refund, less any shipping costs and re-stocking fees.

  • All items returned that are not defective, in NEW condition, and unopened will be applied a 15% re-stocking fee; this fee covers shipping expenses when sent and handling

  • We shall issue the refund upon return (once the item has arrived at our warehouse). All returns will be inspected upon arrival and applied a re-stocking fee of between 15% to 50% dependent on the condition of the item returned

  • The customer must ensure that the item is adequately wrapped, secured and that it includes all components (including free items) when returning the item

  • No components should be missing, including screws, manuals, cables, protective films, plastic coverings, etc. The item returned must be in NEW condition. The factory seal cannot be open in any case


FAILURE TO MEET ANY OF THESE REQUIREMENTS WILL RESULT IN A HIGHER RE-STOCKING FEE OR DENIAL OF RETURN REQUEST