This is a listing for a DIY project kit to build your own Effect Pedal. For clarity, its supplied as a PCB and individual parts which you must identify and put together. This is an electronics project for musicians. The build document is downloaded from my main website. No tools are supplied.

This is a fairly simple reverb circuit. With 1 knob, in case the name wasn't a clue! The pot is a mix pot so dials in the reverb to your dry signal. There are only a few other parts in the main circuit to get you going.

The base kit does not include the Belton Brick, if you need one then there are two options. Short or Long decay, short offers 2 seconds of decay with long going up to 2.8 seconds. Without this the kit will not do much. 

There is nothing too hard to put together on this one. There are only a few parts to identify and the end result is well worth the effort. 

This kit is supplied with a JP1590B enclosure.

Theres a video of our kit here.

  • Whats Included with Each Option

    PCB Only - Just the plain PCB

    PCB & Components - PCB, onboard components and any pots and toggle switches. 

    Full Kit - As above with un drilled enclosure and off board components (foot switch, Jacks, 9v, LED)

    Full Kit & Drilling - Full kit with drilled enclosure.

  • Case Drilling

    Drilling is an optional extra for the Full Kit. There is a small surcharge for this.

     

    Drilling includes all the holes for a complete pedal.

  • Knobs

    You will need 1 knobs for this kit. I suggest you get medum sized. Knobs are not included with the kits.

  • Fair Warning

    Please be sure to read the build document before you order. The kits are enjoyable but can also be challenging.

    You will have to identify components, calculate resistor codes and be able to solder them into place. 

    All kits require full assembly and any images of completed PCBs are for reference only.