Light uv : low viscosity (clear finish)

Thick uv: high viscosity (cloudy finish)

Flexi uv : high viscosity (semi-transparent finish)

Light Flexi uv : high viscosity (semi-transparent finish)

Ruby Red light uv :Low viscosity (red see through finish )

Super flexi blue:high viscosity(blue finish like a rubber)

Super Flexi :Low viscosity(clear finish)

The key factor is one side has to be transparent, which means uv light source must directly expose to the uv glue

For example: you cannot bond two part of metal together. The common feedback is “this glue doesn’t stick even two piece of paper”

One side must be transparent to the uv source to be able to cure the adhesive.

It is best to cure in layers,uv light need to penetrate in to uv adhesive, use a small amount first with uv source,repeat the process.

If uv light doesn’t reach the uv glue “YOU CAN NOT CURE IT”

**Curing depth 3mm

*DO NOT USE UNDER DIRECT SUN LIGHT

*KEEP THE UV ADHESIVE IN ORIGINAL PACKING

*DO NOT LEAVE LID OPEN

Instruction for use

-remove the bottle lids and insert the brush on to the cap

-apply required amount

-use the uv torch/laser pen (if supplied )

-Distance should be between 2cm to 10cm

-uv glue start getting hard after 10 to 30 seconds (depends on amount applied can take longer if used more)

- After glue harden place it under direct sunlight for least 2 -3 hours even on a cloudy day