a kind of inductive capacitance sensor, it must match with an oscilloscope

Close to use, can be used to test a spark ignition secondary overlapping wave, overlapping wave parameters, thus achieved the detection, the diagnosis engine ignition position, make each cylinder ignition voltage changing with time directly from the oscilloscope display.

The loot line has three end, a joint meet oscilloscope for BNC use, a for use, a clip grounding to pick high-voltage gleaned clip with. Loot clincher over is a attenuator, used for loot high-pressure attenuation for low pressure, thus protecting oscilloscope not electrify impact.

 

(1)test clips shall not directly clip in spark plug, should be caught in the connection of the spark plugs of insulation wire, in order to prevent the breakdown and causing a shock.

(2)to distance other high-voltage at least 2 inches apart, lest produce interference.

(3)HT25 leading line length 2.5 meters, the decay of up to 10,000:1.

 

HT201 Feature:

The HT201 has been designed to allow fuel injector and primary ignition waveforms to be measured using Hantek oscilloscope products.

Please note this attenuator should not be used for any high voltage measurements other than fuel injectors and primary ignition.

Specification:
Attenuation: 20:1
Bandwidth: 10MHz
Input Res: 1.053M

 

1* HT25 Auto ignition probe

1* HT201 attenuator