Welcome to our page


For sale we have our BLACK custom-made FORD 4x108 Hubcentric Wheel Spacers sold in pairs 

PLEASE NOTE THESE WILL ONLY BE SUITABLE FOR FORDS THAT HAVE HAD EXTENDED WHEEL STUDS PRESSED INTO THE HUBS

ONLY SUITABLE FOR ALL FORDS WITH HUB SPIGOTS LESS THAN 10MM

***PLEASE MESSAGE US BEFORE PURCHASING, IF YOU DO NOT KNOW WHAT A HUB SPIGOT IS***

DESIGNED, DEVELOPED AND MACHINED IN HOUSE AT OUR BARNSLEY HQ

Spacers are 10mm wide giving 20mm overall increase across the axle.

·         All our custom-made spacers and adapters are manufactured from 6082 T6 MARINE Solid billet Aluminium

One of the most cost-effective mods on the market and easy to fit in 7 steps

• Simply unbolt your wheel and remove.
• Wire brush and wipe the bore and wheel hub clean, (must be dirt/rust free)
• Apply a little copper grease or similar to stop the faces sticking together.
• Slide the spacer on to your existing hub.
• Check the spacer is sitting flush against the original hub with no visible gap
• Gently position the wheel on to the spacer spigot taking care not to damage the machined surfaces.
• Secure the wheel with the extended bolts and torque them to the required spec.

Watfields Precision Engineering also manufacture custom parts as well as wheel spacers and adapters.

All our wheel spacers are manufactured from material sourced in the UK and are produced by Watfields Precision Engineering UK LTD. Visit www.watfields.com

Please contact us to discuss any enquiries you may have