eBay

This Shop Line Kit will replace part of your exhaust system with a mandrel bend performance dual exhaust system on your 1963-1972 Chevrolet C10, C20, C30 GMC 1000, 1500, 2500 (1/2, 3/4, 1-ton) application. All Wheel Bases. 2WD only. 8 cyl (needs two intermediate pipes on either side of the motor). Our Kits will give your truck the look, sound and performance you have been searching for!!

This Corner exit kit will come out under both corners of the rear bumper.

9 2.5 inch saddle clamps and 4 insulated rubber hangers

This kit has the standard size 2.5 inch O.D. tail pipes are included.

Higher flowing and longer lasting mandrel bend pipe is included.

The Rolled Edge Clamp on tips are a polished stainless steel 18" long and 3.5" round. They can either be welded or clamped on.

Two Flowmaster 40 Series mufflers are included. Looking for the original Flowmaster sound? Then take a look at these 40 series Flowmaster mufflers. Designed for use on street and strip vehicles, they take the sound waves produced in the exhaust, and cancel them against angled baffles built into the muffler case. This improves both horsepower and fuel economy. Best of all, these Flowmaster mufflers allow you to hear that cool Flowmaster tone inside of the vehicle, as well as outside of it. So, if you want more power and less noise, then you've gotta get these Flowmaster mufflers.

Please note: This system is designed to replace your factory OEM exhaust starting from the crossmember back. YOU MAY NEED TO SUPPLY AN ADAPTER FOR THE 2.5" PIPES THAT CONNECT TO THE FACTORY INTERMEDIATE PIPES. If your exhaust has been replaced or modified previously fabrication to the existing exhaust on your truck may be necessary for the proper installation of our kit.

Trucks with modified suspension or body lifts may also require fabrication of the exhaust or truck for the proper installation of our kit.

This kit is designed to fit all wheel bases, but may require additional pipe for longer applications or trimming for shorter applications. 8 cyl (needs two intermediate pipes on either side of the motor). GASOLINE ENGINES ONLY

*Product disclaimer: THIS IS NOT A COMPLETE "DO IT YOURSELF" kit. It is recommended that this kit be installed by a professional. Fabrication may be required. Any type of suspension or wheel/tire modifications may affect system clearances. We do NOT include any portion of the exhaust in front of the crossmember. Additional parts or fabrication will likely be required.