Attention.
Because "ZELLO" has officially changed the control method,
Currently does not support the use of the mouse middle button key control.
Only support vox control
We send by default: use 6-pin 16-pin conversion board
If you need to use the 6-pin 26-pin conversion board,
please write to us.
“TX: RED” and “RX:B/G” : This is LED status indictors.
When R1 controls an external radio, R1 lights up red.
When the external radio receives the signal, R1 blue light or green light.
Switch position-MOTO:
Connect 6-pin to 16-pin converter board, used by Motorola radio stations(16-pin interface),(Default accessories)
Connect 6-pin to 26-pin converter board, used by Motorola radio stations(26-pin interface),(Optional accessories)
Switch position -Y, K, C:
Direct connection, YAESU、Kenwood、 ICOM ... Radio use (6-pin TNC interface)
Switch position-ASL OFF:
AllStarLink is disabled, the USB sound card chip stops detecting COS / CTCSS and controlling PTT.
Switch position –ASL ON:
AllStarLink is enabled, USB sound card chip detects COS / CTCSS and controls PTT.
Note2: “ASL ON”, Only use AllStarLink to connect with Raspberry Pi. In other states, the switch position must be in ASL OFF !!!
DIN 6 Interface:
Use 6-pin Cable.R1 to connect YAESU / Kenwood / ICOM-radio;
Use 6-pin cable and "6-pin-16 pin conversion board". R1 connect Motorola-radio;
Use 6-pin cable and "6-pin-26 pin conversion board". R1 connect MotoTRBO-radio;
USB Audio:
USB-Radio Interface, Connect to PC or Raspberry Pi;
USB Detection:
USB mouse middle button detection, connect to PC when running ZELLO or YY...;
USB Serial Port:
USB serial port, connect to PC when running ECHOLINK / PSK31 / SSTV ...;
Package Accessories list :
1X R1 controller
2X USB-D Cable
1X 6 PIN Cable
1X 6PIN-16PIN conversion board