Strong and flexible 3D printed camera mount made of TPU.

No mounting hardware included.

Made to attach a camera to the DJI FPV drone.

Has a recessed location for securely holding an M5 nut.

INSTALLATION INSTRUCTIONS:

1. Remove the top 2 front canopy screws and the top 2 side canopy screws. Use the hex wrench included with your drone.

2. Start all 4 screws into the TPU mount. Use the original screws, longer screws are not required for the install. 

3. Screw in the rear canopy screws first (Don't over tighten), you may find it easier to rotate the mount toward the rear of the drone slightly while fastening the side screws.

4. Rotate the mount forward slightly to align the front two mounting mounts.

5. Screw in the final two screws (Don't over tighten)

6. Install any action camera with GoPro style "fingers" to the mount using the included nut, bolt and 3mm wrench.

NOTE: As mentioned above, do not overtighten the screws, overtightening could cause the TPU mounting holes to become enlarged.