Backbone Adapter + Free Camera Protector For iPhone 13 Pro, Plus, and Pro Max.

This is a slightly different design than the official Backbone 13/14 Pro/ProMax adapter.

Composed of Polyethylene terephthalate glycol, (PETG) this hard and rugged plastic stays attached to your backbone after mounting. 

No more slipping off and getting lost like the soft rubber design sold by Backbone. 

You must open apart the backbone as if you were mounting your phone to place the adapter on the smaller section of the bone. 

From there, it slides snugly along the larger section down to the end of the controller precisely like the official adapter.

No more random disconnections of your controller while gaming on your backbone with a 13/14 Pro, Plus, or Pro Max.

No more random uncased phone drops as your phone slips out from the controller that wasn't designed to hold your phone. 

Included with your purchase is a rugged protective cover for your 13 Pro / 13 Pro Max's camera assembly.

***this free part included in your purchase does not fit the camera assembly on the iPhone 14 pro / plus / max. ***

It should press snugly onto the outside of the camera lenses, sitting flush with the surface of the lens bezel, but may require some light sanding on the inside circles to obtain a good fit.

A dab of loctite might not go amiss either, but typically once snug it shouldn’t fall off unless dropped, and then again can just be pressed back on.

It protrudes just enough to provide protection to the one surface that is most likely to suffer damage from a drop or the like. 

Rest assured as well that your photo/video quality from any of the lenses, as well as the AR camera will be completely unobstructed.

Your flash and mic will also be unaffected, and this cover even fits inside many of those pesky cases that don't provide camera protection!

I swear, Apple straight up be designing these phones to break easier.

Anyway, happy shopping!

Purchases typically ship out on Tuesdays and Fridays.