The cable offers a Lanc Jack, plus video and stereo audio outputs. Our Lanc adapters do NOT influence or alter the LANC protocol. The Lanc signal is passed through from the Lanc controller to the Sony video camera.
LANC Adapter is designed for all new Sony Camcorder that connects the 10pin Sony multi-AV remote terminal jack (A/V R) to 2.5mm traditional LANC jack plus video and audio outputs with RCA connectors. Sony combines audio/video output and LANC signal into one single 10pin multi-AV remote terminal jack (A/V R) on all new camcorders. Most of the new Sony Camcorders don't have the standard 2.5mm LANC jack any more. LANC controls becomes part of the 10pin AV jack. LANC is available but not directly accessible without the adapter cable. This adapter makes the connection between Sony new 10pin connector and 2.5mm LANC possible. No batteries, plug and play, work for all LANC protocol.
for all Sony camcorder with 10 pin AV Jack (A/V R)
AV Sony 10 pin "D" plug
2.5mm LANC remote jack interface
Length: about 150cm
Special Note About the Lanc and Audio/Video Cable:
This cable will NOT work with any of the video cameras listed below due to a change Sony made to these specific camcorders:
2011 USA Models | International PAL Models | |
HDR-CX130 | DCR-SR66 | PAL Camcorders |
NOTE: Sony 2013 Camcorders require a special cable from Sony. The part number is VMC-AVM1 | ||
HDR-CX220 | HDR-PJ230 |
Only the models listed above are affected. If your video camera is NOT listed, then it will work with no problems.
This is what Sony did to these models: ONLY the 2011 video cameras listed above, so when you plug in a cable with a LANC connector, it disables the composite video output. You can still using the HDMI jack to get video out. You can thank Sony for this ridiculous change to the AV/R jack on only the 2011.
So if you video camera is NOT listed above, you have nothing to worry about.