1、Before working, the drive plate and motor seat must be fixed in a large area of metal plate. On, at the same time to pay attention to maintain good air convection, in order to dissipate heat.

2, the factory scanning system are equipped with a variety of connection lines, the user if you use other lines to connect themselves, please note that the reference drive board wiring diagram. Motor serial number and scanning board serial number must be - consistent, X, Y drive board and motor correspond separately, otherwise it will produce pattern asymmetry, such as a circle into an ellipse.

3, the scanning board factory has been adjusted, in addition to the IS potentiometer, the user may not adjust other potentiometers, otherwise it may damage the mirror. According to the requirements of use, the pattern size can be adjusted with potentiometer IS, reverse rotation will increase the pattern, but can not be adjusted without limit, otherwise it may damage the lens. And to X plate and Y plate at the same time to adjust the symmetry, otherwise the hit pattern deformation, such as a circle into an ellipse.

4, please do not plug and unplug the various connection lines with electricity, otherwise damage the lens.

5, pay attention to the protection of the lens. The lens is fragile, in the installation process, pay attention not to collide with the lens, can not have any material contact with the reflective surface of the lens, otherwise dirty the lens or scratch the lens, affecting the reflectivity of the lens, or even burn the lens. Laser dimming, pay attention to the laser beam do not hit the lens glue, because the glue absorbs heat, easy to cause the lens to burn off. When the lens is dirty, available medical cotton with acetone lightly wipe.

6, when the machine appears strange noise or other abnormal phenomena, please immediately shut down, troubleshooting and then turn on the machine, so as not to damage the mirror.