Note: When playing music if suddenly no arc, indicating that the power is too large trigger
The power knob can be turned down, contact customer service to get a special party
wave music;
Use must be placed on an insulated table, otherwise it can not be discharged properly
Size:
14*8cm
Power adapter:
Output: 48V/DC
Input: 100-240VAC
50-60Hz
Arc length:
Wiring method:
Maximum length 10cm
On-board DC5521 standard power hole
Plug and play
Discharge needle:
Removable alloy discharge pin
Support square wave music only
1, first insert the discharge pin, then plug the power 48V plug
2, the switch to the right, open the discharge mode
3, the two knobs are adjusted to the maximum (left screw to the end)
4, plug into the 220V power plug, you can discharge
(If the above steps are completed, the light is on but no arc.
Can find a key or screwdriver or other metal to
touch the top of the arc)
How to use the music mode
First, the pulse width knob right to the end, and then the switch
dial to the left, then connect the Bluetooth, the sound to the maximum
start playing square wave music, and then slowly left-twist pulse width
knob, adjust the power of the arc, note that the power is not too
large, or cause a protection power failure