Minelab Manticore 3D Printed Anti-Brake\Flexing Shaft Insert.

This 3D printed Insert slips into the Manticore shaft Yoke where the coil is mounted to support the Yoke ears from braking & reduce any flexing that may occur when swinging. The new design of the Manticores coil & shaft is a welcomed improvement for those who have had to replace or repair the expensive coils after a yoke ear broke off the coil.(old design) With the new design it will be cheaper if this happens now as the yoke ears are on the shaft instead of the coil. Thanks Minelab! Unfortunately this is bound to happen to some of us out in the field causing down time, Missed treasure & Money so I designed this Yoke Stiffener to help midgait ear brakeage on the Manticore. It fits nicely into the end of the shaft and braces the ears and washers for best performance. It is light weight at about 9 grams & has a drain hole for water in the shaft to escape & is printed with 100% infill = water tight for divers like me.  Made from ASA plastic (Acrylonitrile styrene acrylate) not pla. (Polylactic acid) PLA has a very low melt / deformation temperature. ASA has a higher melt / deformation temperature, High impact resistance, Strong UV & Chemical resistance, Water Resistant with Anti-Static Properties, its Tough and Durable with a low-gloss finish. Better suited for this application. 

&

Minelab Manticore Magnetic Charging Port Cover.
This rubber charging port cover will help protect the connections, keep them clean and reduce the risk of corrosion on the charging connectors. Made from flexible tpu material with a carbon fiber texture on the top that secures to the detector in the same way as the charging cord dose using 2 square neodymium magnets inserted into the part while its printing so they can't come loose ever. Printed using 100% infill = water tight for those that take it into the water like I do. Good luck out there!

&

Minelab Manticore top shaft rubber replacement bung plug.
The upper shaft where the arm cup sits has a rubber bung that can come out and be lost.
This is a replacement bung... Made from Flexible TPU with 100%infill = water tight, has carbon fiber texture on top.


COMBO LISTED TOGETHER TO SAVE ON COMBINED SHIPPING COST.