| Notice
1. Machine during transport will
be shaking before use, to tighten all the screws again
2. Non impregnated with the
slurry particles ingredients
3.Pressure does not prohibit the
use of the viscosity of the liquid, pressure testing machine to test the use of
oil and other
4.The color of parts varies
slightly with different production batches |
| Specification
High pressure pouring machine is the building and
build a chemical grout sealing, structural reinforcement of specialized
equipment
Working pressure: instantaneous maximum pressure up
15000Psi, flow rate of 0.74 liters / minute, chemical pulp can enter more than
0.02mm depth of 1000mm hairline cracks
Machinery components must locking screws, drill
must be fully inserted into the holder, not loose, high-pressure and
high-pressure pipe and the main body perfusion machine gun connections must be
wrapped after the raw material belt tightened to prevent leakage of
slurry |
|
|
| |
|
|
| Machine cleaning method
Wash the machine in time after use, so as not to cause
machine blockage.
1. Before the construction, please prepare the thinner of
the cleaning machine. After the construction, the machine should be cleaned,
such as Tianna water, pine perfume, banana water, etc.
2, cleaning method:
pour the thinner into about 500 ml into the barrel of the machine, put the gun
head into the barrel, clean the boot cycle, wash for a while, squirt, pour in
new thinner, In the same way, the machine must be cleaned, and the second time
the diluent can be used as the first cleaning after the next construction. After
the thinner is ejected, pour the oil into the oil. In the same way, it will be
circulated for a while and sprayed into the oil drum. This will discharge the
thinner and protect the sealing parts inside the machine.
3. During the next
construction, pour the slurry into the bucket, start it first, and drain the oil
remaining in the machine. When the slurry comes out, start
grouting.
|
| Always test the pressure with the oil
before the new machine is used for the first time.
1. The machine will shake during transportation.
Please tighten all the screws before using the machine.
2. Test the pressure
of the machine. It is forbidden to test the working pressure with liquid without
viscosity (such as toluene, acetone, water, etc.). Use oil such as oil to test
the pressure of the machine. If it is empty, the pressure gauge does not show
pressure.
3. Test method: pour the lubricating oil into the barrel of the
machine, close the valve, the gun head is facing the outside, open the electric
drill, when the pressure gauge shows the pressure of 300-400 kg, turn off the
electric drill, open the valve, it will lubricate The oil is sprayed back into
the oil drum, and the pressure test is
successful.
| |