2007-2024 Genuine Buddy Safety LED Light and Taillight Flasher Package

 

Deadlight Running light conversion and Rear taillight flashing modulator for brake lights

 

Improve REAR visibility when riding your Buddy scooter day or night. The brake light modulator causes the stock LED brake light to flash in an attention-grabbing strobe pattern every time the brakes are applied. Each time the brake lever is pulled, the strobe module rapidly flashes the LED brake lights 4 times for 0.4 seconds, then 4 times for 2.6 seconds then lights remain on constant bright mode until brake lever is released.

Improve FORWARD visibility when riding your Buddy with the DEADLIGHT conversion loom. The kit includes the conversion loom that makes your currently inoperable "deadlights" into functional driving lights. Originally intended to serve as turn signals, the original turn signal lights did not pass DOT requirements (the lamps were not far enough apart). As a result, the manufacturer was required to replace them with "pod" style turn signals on the handlebars of the Buddy scooters, leaving the originals disconnected and "dead". This kit, along with the two (2) high intensity LED's will ensure that you are seen as well as improve visibility for the rider.

Kit includes brake light module and the DEADLIGHT conversion loom and two (2) high intensity LED's. Installation typically takes about 10 minutes and only requires a Phillips screwdriver. For DEADLIGHTS, simply remove the front panel housing the deadlights, separate the original 4-pin quick-connect fitting, plug the conversion loom between the two ends (it can only go one way), and then connect the two, 2-pin connectors of the conversion loom to each of the deadlight assemblies. Finally, remove the lens on the deadlight assembly, remove the incandescent bulbs, and reinstall the LED bulbs contained in the kit. For the rear tail light modulator, you simply need to remove the rear tail light assembly, unplug the taillight, and insert the module between the plug ends.

Fits all Buddy 125, 150 and 170i scooters. PLEASE NOTE, THIS KIT WILL NOT WORK ON THE 50cc VERSION. THIS CONVERSION KIT IS NOT COMPATIBLE WITH THE BUDDY KICK EITHER. 

PLEASE CONTACT ME IF YOU HAVE THE 50CC VERSION AND I CAN GET THE KIT FABRICATED FOR YOU FOR THE SAME PRICE.

THIS KIT DOES NOT CONTAIN THE LED TAILLIGHT ASSEMBLY. The LED taillights became a standard feature in 2007. Please ensure that you have the LED taillights for this to operate correctly.

Fits all Buddy 125, 150 and 170i scooters WITH LED TAILLIGHTS. PLEASE NOTE, INCANDESCENT TAILLIGHTS FOUND ON EARLIER MODELS CANNOT FLASH FAST ENOUGH AND WILL NOT WORK WITH THIS MODULE. On earlier Buddy versions (primarily 2006), an LED taillight assembly can be purchased and easily swapped for the stock version.

Please note that due to component availability, your loom may vary in color or design.