Find out more about me and my products at https://sparrowfabrications.co.uk.
Lomography Diana Instant Square Shutter Release Cable Adapter. Please note the cable required is shown but not included. Works with cables such as this one: https://www.amazon.co.uk/dp/B09126NKPN.
Designed by me from scratch to fit the Diana Instant Square camera. It allows you to use a shutter release cable for beautiful long exposure pictures or selfies.
This uses a linear threaded nut to hold the shutter release cable so it is best not to screw the cable in too tight unless you don’t plan on removing it again.
Directions for use
To use:
- Set the exposure switch to B.
- Move the aperture switch fully anti-clockwise.
- Push the upper section onto the lens body.
- Rotate the upper section clockwise so that you can attach the lower section (Photo 5).
- Attach the lower section by firmly pressing both pieces together (Photo 6).
- Rotate the assembled adapter anti-clockwise so that the shutter lever rests on the shutter button as shown (Photo 7).
- Push the assembled adapter back towards the camera body for a snug fit (Photo 8).
- Screw release cable into the adapter as shown.
- Set the Aperture switch to the desired setting.
- After use set the exposure switch back to N again.
Note if you use this be careful if handling the camera whilst the shutter is open or you may spoil your photos by disturbing the adapter!
To remove:
- Remove the release cable from the adapter.
- Move the aperture switch fully anti-clockwise.
- Gently pull the adapter forwards away from the camera body to loosen.
- Rotate the adapter clockwise so you can separate the upper and lower pieces of the adapter without the aperture switch in the way.
- Gently push both pieces apart and remove.
Note the upper and lower pieces of the adapter are purposefully snug so firmly press the lower half towards you and the upper half away from you on each side close to the lugs.
Supported Cameras
Tested with:
- Lomography Diana Instant Square
It is not compatible with the vintage Diana (1960s) and clone cameras from the period, or the Lomography range of new Diana models such as the Diana+, Diana F+, Diana Baby or Diana Mini.
Manufacturing
3D printed in PETG, finished and posted from the United Kingdom. I chose PETG as it is a strong material and the design, although it looks delicate, it is robust.
Questions
If you have any questions please get in touch.