Made from durable 10mm Polycarbonate
Can be used on both hydraulic press and bench vice.
unlike metal dies, acrylic dies allow you to see your piece through the clear material so you can position your piece or pattern exactly where you desire, tape it in place prior to placing it in your press or vice and watch as you add pressure.
Directions for those using a hydraulic jewelry press:
Texture must be done on metal before placing on die. Place your material and put tape so die holds the material, on that a rubber block. You may wish to use two rubber blocks for your desired effect. Apply the hydraulic pressure until from the side of the die, you can see the metal bulge through the die to the desired extent.