Light a room in your dollhouse or the eyes in your Gundam figure with a chip size LED bulb!  

This circuit with an LED chip bulb is great for 1:48, 1:24 or even 1:12!  The circuit is assembled for you with a 3V battery holder, 1 CR2032 battery, an on/off switch, and a quick disconnect to make it easier to route the wiring.  The entire assembly is approximately 15" long.  The bulbs are warm white and give a natural incandescent glow to your room.    Battery is CR2032.

The chip LEDs are a bit larger than nano as you can see in the photos.  Great ceiling light for a larger room or space that needs a light that's just a bit brighter.  Use a single chip LED in the yard to light up the front of your dollhouse! 

Chip bulbs are 3.2mm x 1.6mm and have a bright side and are less bright on the back side.  The quick disconnect is approximately 1/8" x 1/16" to allow for a small drill hole.  The connector works well if you make your light into a lamp and need a 1/8" hole to install the lamp in your room.  The bulbs are so small that a tiny hole is all that is needed  to put the light through a wall, ceiling, or floor.  The distance from the connector to the bulbs is approximately 8" long.  

Also available in double or quadruple bulb circuits as well as custom configurations.

Outside the US - I cannot send a battery with the set due to post office rules. Postage is $22.

Please be aware that any dates given by the post office or eBay are estimates for delivery times only and may vary. We can offer no guarantee on delivery times after it's mailed.    Tracking included in shipping fee.

Please email if you have any questions.