Light your dollhouse with two chip size LED bulbs or use in your Gundam figure !  

This circuit with an LED chip bulb is great for 1:48, 1:24 or even 1:12!  The circuit is assembled for you with a 3V battery holder, 1 CR2032 battery, an on/off switch, and a quick disconnect to make it easier to route the wiring.  The entire assembly is approximately 15" long.  The distance from the connector to the bulbs is approximately 8" long.  The bulbs are warm white and give a natural incandescent glow to your room.  

The chip LEDs are a bit larger than nano as you can see in the photos.  They make great ceiling lights for a larger room or space that needs a light that's just a bit brighter.    Battery is CR2032.

Chip bulbs are 3.2mm x 1.6mm and have a bright side and are less bright on the back side.  The quick disconnect is approximately 1/8" x 1/16" to allow for a small drill hole.  The connector works well if you make your light into a lamp and need a 1/8" hole to install the lamp in your room.  The bulbs are so small that a tiny hole is all that is needed  to put the light through a wall, ceiling, or floor.   

Also available in single or quadruple bulb circuits.  Custom configurations available.

Outside the US - I cannot send a battery with the set due to post office rules. 

Please be aware that any dates given by the post office or eBay are estimates for delivery times only and may vary. We can offer no guarantee on delivery times after it's mailed.    Tracking included in shipping fee.

Please email if you have any questions or want to enquire about custom circuits.