Scott eRide 2019 EMTB Bosch battery rock strike guard 5.7mm thick high density shock dissipating foam rubber shock protection . NOTE - this pad is designed for use with bikes using the battery cover shown on the main photo with a pair of mounting screws on the upper and lower end of the battery cover - 390mm apart.

This rubber is the same high impact shock dissipating cushioning used on the soles of high end training shoes.Other properties,good cushioning, shock resistance, heat insulation, moisture resistance and chemical corrosion resistance, and is non-toxic and non absorbent. The design is specific to the E-ride

The photos of the Specialized , Cube and Haibike  are for reference only. So you see the appearance of the product on e-bikes

For other bike specific models see my other listings.

Protect the down tube / battery case from rock strike and help save the impact shock reaching your battery

This easy to apply protection will save dents and damage and help maintain resale value,

This 2 piece set  guards all of your battery cover / downtube not just the lower part. This area is vulnerable to damage from rocks and Scott supply a lower rubber pad with this in mind.

The Scott pad is 2mm thick but ours is 5.7mm.

Bike models which this pad is designed for eRide Genius, Strike and Axis. Other models may use the same pad but check the dimensions in the photos with particular attention to

the screw hole placements and the breather hole.

The pads come with industrial strength 3M peel and stick adhesive.

This set can be applied in 5 minutes.

Just thoroughly clean your battery and degrease the area with fire lighter fuel, industrial alcohol or other evaporation agent .

This protection kit is bike specific but may work on other models.

A truly useful accessory for damaged prevention and it will keep the frame in pristine condition helping future resale.

NOTE: Make  sure of the alignment when positioning as the adhesive is very grippy.

NOTE 2: When applying the adhesive make sure it is applied in a temperature of no lower than 16C. If you bring a bike indoors from a cold shed or garage keep it in the warm area to allow the surface temperature to warm up, otherwise there may be condensation on the surface which will reduce adhesion.

NOTE 3. Apply firm pressure to the pad, especially on the edges of the curved surfaces. The £m adhesive is designed to hold in wet conditions but it must be carefully applied in the first place

Made and dispatched 1st class from the UK FREE

Dispatched with Royal Mail 1st Class.