This
listing is for 2pc bolts at a time. For those who may have lost or
broken just a single bolt or just a few we may still have another listing. These bolts are hardened metric bolts to mount the
older
style aluminum intake
manifold on many 5.4L equipped trucks. These are the bolts that hold the
intake to the heads. This bolt has the preferred small head (10mm hex)
just as your originals. May also fit many 4.2L motors as well. Please
review the pictures I have included and compare to your originals. They
show the new style bolt and
measurements. Generally if the bolt you are replacing is within 1/4" of
this length you most likely will be OK. You can check with me and I can
attempt to locate the recommended bolt prior to your purchase. We also
do special order request.
This
bolt is an M8-1.25, grade 9.8
hardened bolt with a rust resistant finish. It measures approximately
1-9/16" long behind the head (41mm). This is an upgraded style of
this bolt that has a hex head with a flange. Generally no need to use a
washer. This bolt has a
much better finish than the original bolts. We have seen many selling
this bolt
for as much as $10 per bolt. If you
are changing out your intake manifold (for the common coolant leaking
issue) it is a great idea and piece of mind to replace as much of the
old rusty hardware as possible. They will install much easier and help
provide the important even torque across the manifold. Also if you found
rust or corrosion in the threads, use a thread chaser or tap in threads
in the head to clean out the threads before you reinstall. Size is
M8-1.25x41mm.
More
pictures to come. Listed picture is from one of our other listings. I
will update with actual photos soon. I will include pictures showing
different angles and against a
tape measure for you to compare to your original bolts. This kit is
being setup to use
on the pre 2000 model 5.4L SOHC (2V) engines with the 2-piece aluminum
intake manifold, not the later plastic manifold. This bolt may fit other
applications
including some of the 4.6L engines. Compare to your size. If within a
couple of
mm it will most likely work for your setup but use your best judgement. A
list of trucks that use the same intake manifold is below. You should
see your model listed. Contact me if you need some help or have any
questions. Happy to assist.
UPDATE: Need thermostat housing bolts?
We
frequently have the long bolts available that retain the thermostat
housing in another listing. Those bolts are approximately 90mm long and
also retain the lower intake manifold. When they do sell out they are
normally only 3-5 days out. Contact me for assistance.
TIP:
Follow toque sequence for your manifold. They want you to install it in
at least 2 steps (18 in-lbs, & 18 ft-lbs). We have found the final
toque listed at 18 ft. lbs. but confirm the spec for your intake
manifold.
I will try to find a diagram I can post in the pictures above, but for now you can see the sequence.
Use the most current information you can find available for your make and model.
This is an example of an approved sequence if looking at intake from front & overhead:
firewall side
9 10
5 6
1 2
3 4
7 8
11
Front of engine
description from Ford:
Part Description |
BoltBolt; M8 x 41mm; Attaches intake manifold to cylinder head. |
Required Quantity | for entire manifold: 9pc |