Full kit - rust converter, tank flush, and 2k epoxy 625gm activator and 30gm thinner
High build solvent free 2k epoxy coating designed to provide outstanding chemical and corrosion protection.
Specially formulated for tank lining repair and restoration.
- Use for new lining or to replace failed tank liner e.g. Kreem, Por15, slosh, etc. 1k polyurethane poor-quality coatings.
Tried and tested not only on Petrol, Ethanol and Diesel
But also protects against-
Phosphoric Acid
Sulphuric Acid 98%
Nitric Acid
Steam
Toluene
Xylene
Ammonia Hydroxide and many more
Tested up to
Heat 200c
Flexible 12300psi
Compressive 13950psi
Adhesion 2950 psi
Corrosion 5000hrs min ASTM B117
Cure times- 20C (do not attempt if temp is below 10C )
Usable pot life for fill and rotate method 25minutes
Cure to hard 24 hours
Post cure for use 7 days
Application: Tankroxx will cover and fill pinholes, seam splits and minor surface rust without the need for other lengthy operations. But to be completely safe its best to try to clean and de rust as much of the surface as you can.
Step 1 Remove all oil fuel varnish from the tank using Tankroxx solvent flush or similar
Step 2 Remove all loose rust and debris from tank, again wash all out with Tankroxx solvent
Step 3 Treat rust with Tankroxx rust remover convertor, agitate tank with suitable bead shot or metal nuts screw etc.
Step 4 Wash out with Tankroxx solvent or similar again. Leave to fully dry out.
Step 5 Coating Mix A with thinner 30 gm first, then mix in part B thoroughly, pour into plugged, masked paint protected tank and swirl around to coat the entire surface for 15-20 minutes.
Leave to dry upside down for 24 hours. Full instructions included in every pack.
Storage 5 years unopened.
Colour when dry is Red