TOMS Multi Drive & HAPPY WARP 7.1 & Mini Speedy - to jeden moduł turbo do stacji dyskietek ATARI 1050 zawierający trzy rodzaje turbo. Wystarczy wyjąć oryginalny EPROM i procesor 6507.W miejsce procesora należy włożyć moduł TOMS Multi Drive & HAPPY WARP 7.1 & Mini Speedy. Wycięcie w układzie EPROM i procesorze musi być w tą samą stronę co oryginał.

Na płycie głównej stacji dyskietek Atari 1050 należy wylutować lub wyciąć kondensatory o oznaczeniach C56, C57, C58, C60, C61. Jest to konieczne, ponieważ transfer danych jest bardzo szybki i te kondensatory tłumią sygnał odczytu i zapisu.

Oprócz tego mamy także możliwość odczytu i zapisu dyskietek w podwójnej gęstości czyli 180KB.

Moduły są nowe i przetestowane.

Żeby skorzystać z wybranego przez nas turbo musimy wyłączyć zasilanie w stacji dyskietek ATARI 1050, przełączyć przełącznikiem dołączonego do modułu w inne położenie i ponownie włączyć zasilanie stacji dyskietek. Po przełączeniu będziemy mieli aktywny moduł turbo który wybraliśmy.

Tu mamy film na którym możemy zobaczyć jak wygląda montaż i działanie TOMS Multi Drive & HAPPY WARP 7.1 & Mini Speedy - https://www.youtube.com/watch?v=GF4vy-ocmOI




TOMS Multi Drive & HAPPY WARP 7.1 & Mini Speedy - is one turbo module for the ATARI 1050 floppy disk drive containing three types of turbo. Just remove the original EPROM and the 6507 processor. Replace the processor with the TOMS Multi Drive & HAPPY WARP 7.1 & Mini Speedy module. The notch in the EPROM chip and processor must be in the same direction as the original.

On the main board of the Atari 1050 floppy disk drive, capacitors marked C56, C57, C58, C60, C61 should be desoldered or cut out. This is necessary because data transfer is very fast and these capacitors attenuate the read and write signal.


In addition, we also have the ability to read and write floppy disks in double density, i.e. 180KB.
Modules are new and tested.

In order to use the turbo we have selected, we must turn off the power in the ATARI 1050 floppy disk drive, switch the switch attached to the module to a different position and turn on the power of the floppy disk drive again. After switching, we will have the active turbo module that we have selected.

Here we have a video where we can see how the assembly and operation of TOMS Multi Drive & HAPPY WARP 7.1 & Mini Speedy looks like - https://www.youtube.com/watch?v=GF4vy-ocmOI