Lightweight CO2 Pressure Gauge CO2 Pressure Gauge JIS M22-14 Regulator Manometer
Usage Introduction:
1. Make sure that the cylinder is stationary and locked tightly.
2. Please do not add any
3. Please do not disassemble the device.
4. With the check counter bubble gauge, the reading is accurate, the built-in check reverse backflow can prevent the backflow phenomenon when the cylinder pressure decreases.

Adjustment
Close CO2 gauge, install pressure reducing for connect equipment.
Open the relief for trim switch, and adjust the output. Smaller than required.
Adjusting pressure reducing for 8 hours later.

Warm Tips:
Please note this m22-14 do not fit cylinder in and Canada.
The thread is made according to UK, Europe, Japan and Taiwan standard (JIS m22-14), 22mm in diameter.

Specifications:
Material: Aluminium Alloy
Color: Silver
Thread Diameter: 22mm/0.87"
Input pressure: 0-10mpa
Intake link: GB cylinder interface 8
Outgassing link: M10x1 outer filament
Output pressure: Fine tune out bubble seconds calculation
Quantity: 1 Set

Notice:
Please allow 1-3cm error due to manual measurement and make sure you do not mind before ordering.
Please understand that colors may exist chromatic aberration as the different placement of pictures.

Package Includes:
1 x CO2 Pressure Gauge
1 x Washer