Light your dollhouse or Gundam figure with 4 chip size LED bulbs!  

This circuit with an LED chip bulb is great for 1:48, 1:24 or even 1:12!  Light your dollhouse with four chip LED bulbs already assembled for you with a 3V battery holder, 1 CR2032 battery included, on/off switch, and a quick disconnect to make it easier to route the wiring.  The entire assembly is approximately 15" long and the distance from the connector to the bulbs is approximately 8" long.  The bulbs are warm white and give a natural incandescent glow to your rooms.  

The chip LEDs are a bit larger than nano as you can see in the photos.  They are great ceiling lights for larger rooms or spaces that need a light that's just a bit brighter.     Battery is CR2032.

Chip bulbs are 3.2mm x 1.6mm and have a bright side and are less bright on the back side.  The quick disconnect is approximately 1/8" x 1/16" to allow for a small drill hole.  The connector works well if you make your light into a lamp and need a 1/8" hole to install the lamp in your room.  The bulbs are so small that a tiny hole is all that is needed to put the light through a wall, ceiling, or floor.

Also available in single or double bulb circuits.  Custom configurations available.

Outside the US - I cannot send a battery with the set due to the new post office rules. 

Please be aware that any dates given by the post office or eBay are estimates for delivery times only and may vary. We can offer no guarantee on delivery times after it's mailed.    Tracking included in shipping fee.

Please email if you have any questions.