happyeasybuy01
Add to my favorite sellers
Mon. to Sat.

Customer Service

Warranty Service
Specifications

Supply voltage: 3.3-5V (5V recommended)

Operating current: less than 50mA, the typical value is 35mA.

Serial port parameters: baud rate 9600 bit/s, data bit 8 bit, no parity check, 1 bit stop bit

Interface function: the module adopts three kinds of interface output

Product Description
RDM6300 RFID Card Reader Module 125khz UART Serial Built-in Antenna RF Module for Low Frequency ID Cards
Feature:
1.This product is a 125KHz RFID swipe decoding module, and integrates the antenna in the PCB. The interface adopts 5PIN interface, which are VCC, J1, Tx, J2, GND. 
2.At the same time, the power supply adds Schottky diode for anti-reverse connection protection. This module is suitable for most low frequency ID cards. 
3.The module has 3 output modes: UART output, IO direct output, and triode open-drain output.

Specification:
Supply voltage: 3.3-5V (5V recommended)
Operating current: less than 50mA, the typical value is 35mA.
Serial port parameters: baud rate 9600 bit/s, data bit 8 bit, no parity check, 1 bit stop bit
Interface function: the module adopts three kinds of interface output
1. Pin Tx uses UART to output data, the output data format is 10 ASCII codes + 1 space, and the card number is 10 data (see Figure 1). The baud rate setting is sampled in the manner of Figure 1 to receive data.
2. If the product does not need to use the UART to read the specific card number, you can directly read whether the card swipe is successful through the IO port of J2. When the card is swiped successfully, it will be accompanied by UART data output. During the data output period, the J2 port remains high. After the data output is completed or in the idle state, it always outputs a low level.
3. The J1 port and the J2 port have an opposite level, but this port is an open-drain output, and the corresponding level can be output through a pull-up resistor. It can also be connected to 12V load and 24V load. This port is designed to be upgraded for subsequent products, driving relays, etc. The sink current of the port can not exceed 100mA. (If the customer needs to directly drive the relay, the corresponding program needs to be replaced)
Product size: about 43*40*4mm
Product weight: about 10g
Packing size: about 90*90*10mm
Packing weight: about 10g

Note:
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow 1-2cm measuring deviation due to manual measurement.
Included

1*RFID Card Reader Module

  1. * We accept PayPal only.

  2. * All major credit cards are accepted through secure payment processor PayPal.

  3. * Payment must be received within 7 business days of auction closing.

  4. * If you have bought multiple items from me, you can send me one payment for all the items instead of paying for them individually. When you click the Pay Now button, eBay will automatically determine if there are other items you have won or purchased from me and will combine them for your review.

  5. * Refunds are normally issued with 2 working days.If you need any further information regarding payments,please contact us via eBay message.
    * If you have any special requests, please send us a message before making the payment.

  6. *NOTE: Import duties, taxes and chargers are not included in the item price or shipping charges. These charges are the buyer's responsibility.
    Please check with your country's customs office to determine what these additional costs will be prior to bidding buying.

  1. * 12 months Warranty. Buy with confidence!

  2. * If you are not satisfied when you receive your item, please return it within 14 days for a replacement or money back. Please contact me before you return it.

  3. * If item is defective in 3 months, We will send you a replacement without extra charger, or offer refund after we receive the defective item.

  4. * If item is defective after 3 months, you can still send it back to us. We will send you a new one after receiving the defective item. But you have to pay the extra shipping fee.

  1. * We ship from the item location.

  2. * Items will be shipped within 3 business day(S) after payment completed received.

  3. * NOTE: Please check the parcel before sign for it, If any problem with the parcel please mark on the signature that "Damaged when received" when signing it. Thank you.

  1. * We are not responsible for any custom duty or import tax.

  2. * We will leave POSITIVE FEEDBACK after receiving the payment. Please contact us if you are not satisfied with the item after receive it.

  3. * All messages will be answered within 1 business day. If you do not receive our reply, please kindly re-sent your message and we will reply to you as soon as possible.

  4. * Serious Buyer Only! Please place bid only if you agree with all the terms.

  5. * If you have any problems or concerns whatever with your order or products, please message us and give us a chance to assist you before you leave any feedback. We believe we can produce a positive outcome to any situation and will work hard to earn your praise.

  6. * If you were pleased with this transaction, Please give us 5 star rating, thanks!

  1. * Our office hours are 9:00 a.m to 6:00 p.m (GMT +8) of Monday to Saturday.

  2. * And our Office is closed on Sunday and public holidays.

  3. * We apologize for the late reply during the holidays.

Am 01.04.2024 hat der Verkäufer die folgenden Angaben hinzugefügt:

DataCaciques