Collecting listings has surprises
Description
BASE is a feature rich electronics solution for Reprap and other CNC devices. Its five motor outputs are powered by A4982 stepper drivers.4, it adds heating output. Relative to the Ramps1.
. BASE is suitable for 3D printer manufacturers on production, and being used as main control board. The board can use the firmware as Ramps1. BASE is designed to be flexible in the user's power source availability, allowing any power supply from 12V-24V.4. It features an onboard AT
Features
- 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)
- Easy connect TFT on AUX-1
- 3x temperature connectors for thermistors
- fuse for short-circuit protection.
- Warm Tip: Dear buyer, Due to lighting effect,monitor's brightness,manual measurement and etc, there could be some slight differences in the color and size between the photo and the actual item. sincerely hope that you can understand! Thank you!
- Easy DISPLAY + SD-CARD connector,RepRapDiscount SmartController compatible pin header on board
- Up to 5 motor driver with A4982
- 4 layers PCB, optimize heat dissipation.
- compatible At and FT232 processors are compatible with all RAMPS class firmware
- Firmware can use the configuration as ramps1.4
- Color: As shown
- Material: Plastic and metal
- Size: 11x9x2cm
Controller Panel Board for 3D Printer