eBay

Throttle Range Calibration:

Test video1:

EXPLORER 1850KV :

EXPLORER 2250KV :

Rhino Crawler 80A has one USB Link for free

This ESC preloaded AM32 custom firmware. It's optimized for crawler and makes your car run super smooth and quiet, but it is also suitable for a variety of 1/8 scale or smaller cars. A built-in adjustable four voltage BEC with a maximum current 10A to apply the high torque servo. In addition, the e-Switch that comes with it avoids failures caused by harsh environments.

All wires are pre-soldered.

Feature
AM32 custom firmware
Sinewave startup allows the motor smoothly at ultra-low speeds Variable drive frequency
Low voltage, throttle loss and stalled rotor protection
High-performance 32-bit MCU
E-switch with long life and waterproof

Specs
Product Num.: A3100
Battery: 2~8S Lipo
Current: 80A cont.
BEC: max 10A, output 5.2~8.2V adjustable by DIP switch
Waterproof: ESC not supported / e-switch supported
FAN: not include, solder pads for power is reserved
Connectors: not include
Wires: battery 14AWGx150mm, output 14AWGx150mm, signal 250mm and e-switch 120mm
Dimensions: 60x29x15mm (without wires)

About RhinoCrawler RM-S20 Brushless Motor:

RhinoCrawler RM-S20 (540) is an extremely torque dense and lightweight choice with exceptional startup! It has more mounting positions, beefier wire retainer, and thicker back iron. RM-S20 is very difficult to produce, and it is currently the smallest size of the 2820 stator, the outer size of the RM-S20 stator 2820 is only 35x32mm! In addition, it adopts a specially customized dual tile strong magnetic design, which makes the motor lightweight and has stronger explosive power on the basis of small size!

Featrues:

1:10 rigs

Competitive RC Rock Crawling

16ga silicon motor leads

Hollow Shaft for lightweight

Specs:

KV: 1450KV / 1800KV / 2220KV

14 pole 12 slot stator

8.4V -16.8V (2-4S) LiPo

1/8" D (3.17mm) shaft output

25mm Mounting holes for M3 screws

120g with wires, without connector