Method of spraying varnish:
It is recommended to spray twice, place a hand-held varnish bottle at a horizontal distance of 20 cm from the pattern, spray a thin layer, the pattern must be completely covered with varnish, let it dry naturally for 30 minutes, and then spray a thin layer again. at last let it sit for more than 3 hours to dry naturally, or dry it using hairdryer at low temperature.
Spray coating is a very important step during transfer, please pay attention to the following points:
Step 1: Print with LaserJetPrint your design on the BLANK side of the transfer paper. Please complete the settings below before print:
| Step 1: Print with InkjetPrint your design on the BLANK side of the transfer paper. Please complete the settings below before print:
The settings may vary based on different brands:
| Step 2: Spray Acrylic CoatingAfter the printed image dries out. Method of spraying varnish: It is recommended to spray twice, place a hand-held varnish bottle at a horizontal distance of 20 cm from the pattern, spray a thin layer, the pattern must be completely covered with varnish, let it dry naturally for 30 minutes, and then spray a thin layer again, at last let it sit for more than 3 hours to dry naturally, or dry it using hairdryer at low temperature. NOTES:
|
Step 3: Cut Out Your DesignUse scissors to cut out your design. | Step 4: Soak In WaterSoak the image in water for 15~25 seconds to separate the backing paper and the transfer film. NOTES: Don’t soak the image too long, or the film would break during transfer. | Step 5: Slide the BackingPick up the decal paper from water, then quickly apply it to the ideal position of your candle. Gently apply the image to the candle. At this time, you can easily slide away the backing paper. |
Step 6: Remove Bubbles and WaterAfter placing the transfer film, use a damp cloth or tissue to remove all the air bubbles and excess water. Make sure there is no bubbles between the image and the candle. NOTES: If the bubbles don’t remove completely, the decals would be easy to peel off. | Step 7: Dry Naturally
For the bakeable items, like mugs, cups and more, you can bake it in the oven for best stickness.
| Step 8: DoneCongratulations! Transfer has been done, Enjoy! NOTES: Ceramics and glasses are NOT dishwasher safe. Please clean it by hands gently. |