CWL1000 Tailstock Conversion....turn your tailstock into a drilling facility, not possible on standard stock.

Will fit the newer Clarke 1000B 

18mm x 2.5 (10 TPI)

Conversion 1/2" chuck + 7 1/2" threaded piece allowing you to drill up to 4". Will fit any woodlathe with a tailstock thread of 18mm (kit available for the old CWL1000 3/4" BSW 10 TPI). 

Specially made in our engineering workshop

PLEASE check your lathe before ordering.

Also available - 8 piece wood turning chisel set, mortising bits, lathe chucks, screw chuck....please visit shop

If you have any questions, please ask, thanks for looking

Postage applies to mainland UK only, does not apply to offshore, or Highlands and Islands. If you need this item sent to any of these locations or you aren't sure please let us know and we will opt for a different courier, however they do normally take 3-5 business days. Thanks