The best location for mounting any electric fuel pump is the rear of the vehicle. The inlet and outlet of the pump must be mounted below the lowest point of the tank. This is necessary to allow for an adequate fuel supply. The pump is designed to push fuel and not designed to suck fuel out of the tank. It needs to be gravity-fed or if it’s pulling from the top of the tank, it needs to develop a siphon feed to the pump. The pump should be mounted on the chassis, IN A VERTICAL POSITION WITH THE PUMP MOTOR ON TOP. Avoid exposure of the pump and fuel lines to moving parts and to any hot areas, such as the exhaust manifold. The pump should not be mounted in a closed area, such as the vehicle’s trunk.
This is a 12 volt pump and the pressure is NOT adjustable. Pressure is pre set at 7 psi and maintains 5 psi while flowing 67 gph. If less pressure is needed you will need to also order a regulator such as part number 56058500. Pressure needs to be supplied as specified for the carburetor in use. Using too much pressure will force the fuel past the needle and seat in the carburetor and cause excessive fuel in the engine and the related problems.
Speedway Electric fuel pump is a standard pressure street pump for gasoline only. It has a maximum pressure preset of 7 psi and a free flow capacity of 97 gph. It flows 67 gph while maintaining 5 psi. No regulator required.
- Internally regulated at 7 psi
- Gravity fed fuel "pusher" design
- Mount below lowest point of fuel tank
- 3-1/2" from mounting bracket surface to the very front of the pump
- Fittings included with pump are 5/8"-18 o-ring thread to 3/8" hose barb
Notes
Flows 67 GPH while maintaining 5 PSI, regulator not required.
Inlet Fitting
3/8" hose barb
Outlet Fitting
3/8" hose barb
I would buy this product again
Rated
by Alaska Mini Racer on October 24, 2016
Summary: Great pump for the money
Pros:
Prtetty Quiet Pump
Cons:
None
Yes, I recommend this product.
Excellent product
Rated
by Hotrod Skip on October 12, 2016
Summary: Supply fuel to two 4 barrel Carburetors, noise is livable.
Yes, I recommend this product.
great pump right size for location
Rated
by johnny1949 on April 03, 2015
Summary: Easy installation also good pressure for fuel system
Pros:
Good Quality
Quiet, Efficient and a Very Reasonable P
Rated
by bostonbill on September 24, 2014
Summary: The pump on my 29 A coupe died a premature death. thought I'd try this Speedway pump. As usual, rapid delivery. Quality is excellent. After a simple installation I tried to start the car. When I turn on the ignition I thought that the pump was inoperative. I crawled under the car and the pump was humming away. It worked perfectly. Drove 135 miles the next day and the pump never skipped a beat. An excellent buy!! Thanks Speedway!!
Yes, I recommend this product.
happy, happy, happy
Rated
by RacerX123 on September 13, 2014
Summary: So far so good. I've put on several hundred miles in the last month and no problems.
Pros:
price and it slipped into my holley mount.
Cons:
None
Yes, I recommend this product.
Shipping Policy:
-
Please pay for all items at the same time.
-
If shipping rates do not combine properly, contact us or send a buyer requested total.
-
You must contact us before making payment to combine your items.
-
Failure to do so will result in separate shipping fees for each individual item.
-
We cannot combine your order if you have already paid.
Some products are too large for standard ground delivery and must be shipped via truck freight.
When possible, please provide a business or commercial address for delivery to eliminate additional fees.
Please ensure the phone number provided is accurate to avoid delays. Upon delivery, the recipient
must inspect the shipment before the driver leaves as there may be concealed damage; please open the
carton to inspect the contents. Any visual damage must be noted on the shipping document BEFORE signing
for delivery. Any damage not noted before signing for delivery is the buyer’s responsibility. If
damage is found, the shipment may be refused, but please contact us as soon as possible and arrangements
will be made to have the product replaced and damaged parts returned.
We're here to help before and after your purchase. If you have a question or need assistance
with one of our products, please contact us through eBay Messaging and a knowledgeable
Speedway Motors team member will be happy to help.
Speedway Motors is America’s Oldest Speed Shop® and has been a trusted
source for specialty rodding and racing products and friendly expert
advice for more than 66 years. Founded in 1952 by “Speedy” Bill
Smith – a racer and street rodder himself – Speedway has grown from a
one-man operation to become the world’s largest manufacturer, distributor
and retailer of street rod and racing products. Our industry-leading
fast delivery is the result of same-day shipping from our state-of-the-art,
centrally located 500,000 sq. ft. headquarters. Speedway’s size offers
customers unmatched product selection and low pricing, while our excellent
technical support and customer service have made us a recognized leader
in the rodding and racing industries.
We want you to be satisfied with your purchase. If within 60 days after you
receive your shipment and you are not satisfied, you may return the item for
a refund or an exchange. Refunds will be processed (1) day after the item is
received by Speedway. All exchanged or returned merchandise must be in original
factory condition with no modifications or alterations.
Returned merchandise must include all packaging materials, warranty cards, manuals,
and accessories. If the items being returned need to be repackaged, there will be a repacking
charge. Repack the item in a sturdy box, include a copy of your invoice and
complete the form on the back of the invoice. You must ship orders back PREPAID.
WE DO NOT ACCEPT COD SHIPMENTS. All exchanges need to have reshipping charges included.
All fiberglass items returned will be subject to a 15% restocking charge. No returns
on electrical parts, DVDs, and books unless they are defective. Absolutely
no returns on special order or closeout merchandise.
Speedway accepts full responsibility for the accuracy of our listings and product
representation. If an egregious shipping or description error occurs, the customer
will be refunded in full or sent the correct item at no additional cost.
Due to our large inventory and the diversity of our product line, the stock photo
used may not be an exact representation of the item you are bidding on. Please
read all product information carefully before purchase to avoid any order issues.