A complete electronics project kit for Raspberry Pi with instructions for Scratch.

Contains:
  • Mini breadboard
  • Breadboard cables x 10
  • 5 volt buzzer
  • Push button switch
  • Light Sensor (light dependent resistor LDR)
  • Thermistor (heat sensor)
  • NPN transistor 2N3904
  • Capacitor 100uF
  • Capacitor 1uF
  • 3x LEDs - red, green & yellow
  • 3x 220 ohm resistors 
  • 1x 1k resistor
  • 1x 2.2k resistor
  • 1x 3.3k resistor
  • 1x 10k resistor
  • GPIO pin out reference card
  • Download link to PDF tutorial and code examples.
Also includes a download link to our own PDF guide that shows you how to use the Scratch programming language to:

1. Flash an LED on & off
2. Get input from a push button switch & make the cat meow.
3. Use a push button switch to toggle an LED on and off
4. Traffic lights sequence with red, yellow and green LEDs
5. Turn the buzzer on and off using GPIO
6. Use the transistor as an electronic switch turn the buzzer on and off (louder).
7. Get a reading from the light sensor (LDR) and have the cat complain when it goes too dark.

You can also download the Scratch programs directly from our server to your Raspberry Pi.

Tested with a Raspberry Pi 4.

An electronics project kit suitable for beginners, with full instructions and email support.

UK postage is free. International Signed For postage is £7.99

Doesn't include Raspberry Pi computer.

Raspberry Pi is a trademark of the Raspberry Pi Foundation.